Mill Details

Meytre Mill

Burke Co. | North Carolina | USA
Known Dates: 1906, rebuilt 1982
Township: Lovelady Twp.
Watersource: Tributary of Cataba River.
Location / Directions

Meytre Mill

From Hickory, go west on I-40 to exit 112 at Valdese. Go north into Valdese on Eldred St SE and turn west/left on Main Street, go 0.8 miles to Church Street. Turn right/north on Church St. and go about 1.5 miles to McGalliad Falls Park on the right. Park in the parking lot and take a short walk to the mill.




View Larger Map
Verse for Thought
The one eternal God, Whom earth and heav'n adore; For thus it was, is now, And shall be evermore. "Now Thank We All Our God" by Martin Rinkart 1586-1649
({From the Nazarene Hymnal - Sing to the Lord})
Meytre Mill
Robert T. Kinsey 10/20/2010

The mill, built in 1906 by Fred Meytre, was the Meytre Grist Mill, situated at the McGalliard Falls.

Meytre Mill
Robert T. Kinsey 10/20/2010

The waterwheel measures approximately 2.5 feet in width by 16 feet in diameter.

Meytre Mill
Robert T. Kinsey 10/20/2010

The waterwheel pictured from an angle below the wheel.

Meytre Mill
Robert T. Kinsey 10/20/2010

The mill structure just north of the easternmost parking lot.

Meytre Mill
Robert T. Kinsey 10/20/2010

This collection basin collected water to funnel water down the sluice apron to the overshot wheel.

Meytre Mill
Robert T. Kinsey 10/20/2010

The old wheel actually washed out in 1916, after only ten years of use. It was replaced with a turbine which powered the mill from then on to 1941, when it ceased operating.

Meytre Mill
Robert T. Kinsey 10/20/2010

The mill, rebuilt in 1982 when it was made into a park, from below the mill about where the waterwheel is located. . The mill remained in operation by Mr. Meytre until 1941, when he became too old to operate the mill without the help of younger men. These men were very hard to obtain, as most were being called to serve in the war effort from 1940-194

Meytre Mill
Robert T. Kinsey 10/20/2010

The lower portion of the sluice apron as it ends over the large waterwheel. Meytre operated the mill until 1941, grinding corn for corn meal, wheat for flour, and operating a hammer mill for livestock feed production.

Meytre Mill
Robert T. Kinsey 10/20/2010

A shot of the interior through a window or knothole.

Meytre Mill
Robert T. Kinsey 10/20/2010

This area of North Carolina was settled by a religious order known as Waldenseans. These were free Christian of France, who in the 19th century, established refuge in northern Italy, after enduring centuries of persecution in France. GPS: 35' 45.93'N, 81' 34.11'WEle. 1,093'/333 meters Drexel Quadrangle

 
Upload Pictures
I want to upload picture(s) at this time.